PURPOSE To calculate the output factor (OPF) of any irregularly shaped electron beam at extended SSD. METHODS Circular cutouts were prepared from 2.0 cm diameter to the maximum possible size for 15 × 15 applicator cone. In addition, two irregular cutouts were prepared. For each cutout, percentage depth dose (PDD) at the standard SSD and doses at different SSD values were measured using 6, 9, ...

In this paper the effects of circular and elliptical cutout on the buckling behavior of a sixteen ply quasi-isotropic graphite/epoxy symmetrically laminated rectangular composite plate [0°/+45°/45°/90°]2s, subjected to various linearly varying in-plane compressive loads, numerically. Further, this paper addresses the effects of size of elliptical cutout, orientation of elliptical cutout, plate ...

This paper investigates the buckling of finite isotropic rectangular plates with circular cutout under uniaxial and biaxial loading. The complex potential method is used to calculate the pre-buckling stress distribution around the cutout in the plate with finite dimensions. To satisfy the in-plane boundary conditions, the generalized complex-potential functions are introduced and a new method b...

The lateral buildup ratio (LBR) used to estimate the depth dose distribution of electron beams for an irregular cutout field was obtained for a 4-MeV energy beam from a Varian 21 EX linear accelerator. The depth-dose curves for a group of circular cutout fields starting from a 2-cm diameter were measured. Electron diodes were used in a large water tank to measure the LBR values for 6, 9, 12, an...

In this paper, simulation and analysis of thin steel cylindrical shells with elliptical cutouts under oblique loading were studied using finite element method. First, the numerical results were validated by the results of experimental test performed by an INSTRON 8802 servo hydraulic machine. Also, the effect of cutout angle (θ), cutout size, cutout position (L0/L) and cutout aspect ratios (b/a...

In this work, finite element analysis has been done along with experimental test and conducted using numerical tests of the buckling response quasi-static compressive loading six layers woven cross-ply laminated composite material [0º/90º/0º] centrally square circular cutouts. The effect cut-out shape its size a load were obtained experimentally numerically. Compression experiment performed by ...

OBJECTIVES To establish a laboratory model of implant cutout, which can evaluate the effect of implant design on cutout resistance in a clinically realistic "worst case" scenario. SETTING Orthopaedic biomechanics laboratory. DESIGN Implant cutout was simulated in an unstable pertrochanteric fracture model, which accounted for dynamic loading, osteoporotic bone, and a defined implant offset....

The increasing trendof constructing componentsmade of composite laminates is due tothe flexibility intailoring their properties and high strength-to-weight ratio. Nevertheless, most practical components involve cutout features for fastening these cutouts could significantly reduce the strength laminate. Due to its importance, many studies were conducted study effect circular however, there lack...